Freedom Finger Triggers Glock Forced Reset Trigger (FFT CUT V2)

Stainless steel trips and 3D printed PLA+ trigger shoe for Glock 17, 19, 19X, 20, 21, 22, 23, 26, 43X, 48. You must disassemble your existing trigger assembly to install. COMES WITH A DURABLE TRIGGER SHOE AND FFT CUT TRIPS (3 sizes). Oil your gun for best results, especially the top of the barrel/underside of the slide. WARNING this does NOT have a trigger safety.

*NOT TESTED WITH AFTERMARKET SLIDES OR BARRELS. WE CANNOT GUARANTEE PROPER FUNCTION ON THEM.*

The trigger is NOT compatible with an ambidextrous slide release/catch (Gen 5). You must remove it or replace it with a Gen 1-4 slide release/catch to keep that function.

WARNINGS:

• By purchasing or using this product, you are accepting responsibility and liability for the serviceability of the final installation, as well as any damage or wear that may occur to your firearm.
• Improper installation or use of this device may lead to unintentional discharge of the firearm that may lead to injury or even death.
• We recommend installation be performed by a Professional Gunsmith.
• After the device has been properly installed, it is imperative that all users seek qualified training on how to use this product.

***FOR BEST RESULTS PLEASE FOLLOW THE OPTIMAL SETUP BELOW***

We will not ship to any of these states. Florida, California, Colorado, Connecticut, Delaware, Hawaii, Illinois, Maryland, Massachusetts, Minnesota, Nevada, New Jersey, New York, Oregon, Rhode Island, and Washington.